Leaf dermaplaner bridges the gap between in-clinic visits with your esthetician. The blade sharpness and high-exposure ratio make it more effective than cheap disposable tools with closer exfoliation and smoother results.

1x Dermaplaning Tool, 2x Refills (2x blades & 2x blade-guards), 1x Precision Clip

Loading Your Dermaplaner Before using your Leaf Dermaplaner, read through all instructions carefully. Exercise caution when handling blades, loading blades, and using the razor. The blades are sharp and may cause injury if not loaded and used properly. You should not use the razor if you are unable to safely load and handle the blades. Do not use the Dermaplaner unless both the blade and the blade-guard are properly installed. Use each blade and blade-guard up to three times before refilling your tool. Your Dermaplaner comes with your first blade-guard already installed. All that's needed is to unwrap a fresh blade and install that. To install the first blade, thumb the head of the tool open, unwrap a blade, and insert it between the flaps of the blade-guard. Push the blade forward once it's between the flaps of the blade guard and press it down from the back. This will be a tight, friction fit that will force the edge of the blade up against the inside of the blade-guard. Be sure to ensure that the blade sits within the blade-guard and not on top of the blade-guard. Preparation Thoroughly clean your face's skin with a non-exfoliating cleanser to remove any makeup and skincare products. Apply a small amount of Shave Oil to your skin to help the dermaplaning blade glide. Dermaplane Hold your skin taut behind the tool and place the blade at a 45� angle against your skin. Begin dermaplaning by using light pressure and moving in short, feathery strokes. Start high on your cheekbone and move inward / down along your cheek and jawline. Continue along your forehead moving downward. Use above your lip and along your chin as desired. Avoid use on your nose. Rinse or wipe the blade throughout use and most importantly take your time. After Care When you're finished, rinse your skin and apply Calming Serum for a layer of protection and soothing. Avoid direct sunlight immediately after dermaplaning and consider use of a SPF. Avoid chemical exfoliation products immediately after dermaplaning. Rinse your tool thoroughly. Remove the blade and rinse it thoroughly, disinfecting it with a wipe of rubbing alcohol. Rinse and disinfect the blade-guard while keeping it in the tool. Re-load the blade for next use, unless it's time for a refill. Don't use your blade and blade-guard more than three times prioritize fresh and clean tools when working with your face's skin. If you're ready to reload, reach behind the blade and push it forward while pulling up. Once the blade is removed, turn the Dermaplaner over and use a coin or other thin object to push out the blade-guard. Install a new blade-guard by inserting the short leg of the guard through the slot from inside the dermaplaner head. Finally, unwrap and load a fresh blade.

Metal

Rinse your tool thoroughly between uses. Remove the blade and rinse it thoroughly between uses as well, disinfect it with a wipe of rubbing alcohol. Rinse and disinfect the blade-guard while keeping it in the tool. Re-load the blade for next use, unless it's time for a refill. Don't use your blade and blade-guard more than three times prioritize fresh and clean tools when working with your face's skin.